Page 1 of 1
Ideas for the flywheel
Posted: Thu Jan 24, 2008 2:35 pm
by Adansito
Building my first walking beam engine. What is used to connect the flywheel??? Any ideas are welcome. Remember I'm new to all of this!!! thanks!
Adam
Posted: Sat Feb 09, 2008 11:06 pm
by Cartech
I have not built a walking beam but skateboard wheel bearings work? not sure if you mean the flywheel or the connecting rod but either way, a ball bearing will be the way to go. I have also found that R/C car wheel bearings are great for connecting rods and should only cost about 3.00 at the hobby store. A 4x8 milimeter is easy to work with, just use a pin to remove the seal and clean out the grease, same for skate bearings.