RPM speed controller

Discussion on Stirling or "hot air" engines (all types)
Post Reply
Wellington
Posts: 143
Joined: Mon Apr 18, 2016 4:02 am

RPM speed controller

Post by Wellington »

I need a super simple way to control the rpm on a horizontal alpha engine so as to not overcharge a battery. I've seen centrifugal governors on steam engines but these require machine shop tooling to make. Is there a super simple way to control rpm mechanically without machine shop tooling?
Thanks
Wellington
Ian S C
Posts: 2218
Joined: Thu Dec 02, 2010 5:15 am
Location: New Zealand

Re: RPM speed controller

Post by Ian S C »

Wellington, if you built a Stirling Engine good enough to power a generator you could probably make a governor, but how about going the other way and put a voltage regulator on the out put of the generator, there are plenty of circuits on the net for a simple design. you will need a voltage regulator IC, some resistors and capacitors, and a little bit of Vero Board, or similar, or you can probably just solder the bits together. With some types of regulator(LM 317) it can be made adjustable.
Ian S C
Post Reply