Page 1 of 1

Energy from a Stirling Generator

Posted: Wed Feb 08, 2017 9:03 am
by StirlingEnthusiast
Hello,

How much energy would come from a small, two-cylinder Stirling engine? How can I improve efficiency?

Re: Energy from a Stirling Generator

Posted: Wed Feb 08, 2017 4:21 pm
by thanh-cuibap
Hi StirlingEnthusiast !!
this is my stirling http://www.stirlingengineforum.com/view ... f=1&t=2190 , it's not enough output 6 volt , so i must be make add the voltage increases

Re: Energy from a Stirling Generator

Posted: Thu Feb 09, 2017 1:58 am
by Ian S C
Here is my Ross Yoke ALPHA motor with a little power hacksaw, 20 / 30 minutes to cut a 12 mm steel bar.
Ian S C
[img]
Test 011 (640x480).jpg
Test 011 (640x480).jpg (204.37 KiB) Viewed 3727 times
[/img]